Blog Archives

WIP: Privateer Press Convergence of Cyriss Mitigator Cont.

Next step on my Project Orange Crush Mitigator was to dry-brush from top down only with Vallejo Liquid Silver alcohol-based metallic. I really like the finish the alcohol-based metallics give, but they can be difficult to work with. The flakes tend to get everywhere and the paint travels differently than acrylic paint because of the differences between alcohol and water, so you have to be very careful with it. Because this model is currently all metal anyways, and because I was only dry-brushing, I didn’t have to worry about these things this time thank goodness!

The dry-brushing added an extra level of shininess to the highest lights and edges of details on the model.

12 13

Afterwards I sealed it again with varnish. The next thing I’ll be working on is the orange glow!

Advertisements

WIP: Privateer Press Convergence of Cyriss Mitigator Cont.

The next step on the Mitigator was to gloss varnish and do a black watercolor wash all over. I typically use either liquitex ink or GW washes, but I’ve been wanting to try an oil or watercolor wash for a while. A wash that you can apply and then clean up with a solvent or water sounds really appealing to me as I’m pretty tired of things drying wrong and having to use paint to fix it.

2013-11-04 15.53.44

 

Turns out you can be about as messy as you please with the watercolor because it cleans up beautifully. After cleaning the watercolor wash with a wet Q-tip I sealed it with gloss varnish again. Then, I further defined some shadows and lights with the Reaper metallics I used previously and added Reaper scorched metal to the mix.10

WIP: Privateer Press Convergence of Cyriss Mitigator Cont.

Next I used Reaper Sparkling Blue and Reaper Blackened Steel to add more definition to shadows, and I used Reaper Polished Silver to bring up the highest lights. This was the first time I sprayed Reaper metallics through my Badger Krome, and, to be honest, it wasn’t that pleasant. It worked out in the end, but I spent the entire time fighting almost instant dry-tipping and clogging. I’d prefer to spray Vallejo Model Air only in the future!

20131102_123018

WIP: Privateer Press Convergence of Cyriss Mitigator

Well I’m finally able to start on the model I’m painting for Project Orange Crush – Convergence of Cyriss Mitigator.

Here are all the bits once I split them out of the Convergence of Cyriss Battlegroup Starter Box:

Cyriss Mitigator WIP 1

 

Lots of tiny bits, although Syntherion was worse!

Then I got started on the mould lines, and boy were they bad! I’ve worked with a few Privateer Press models before that didn’t have nearly the mould lines this model did.

This is as far as I got cleaning it while re-watching an episode of The Walking Dead:

Cyriss Mitigator WIP 2

 

More mould line cleaning tomorrow, and then hopefully I can get it primed! I prefer to let the primer have at least 24 hours to cure before I apply paint, and I’d really like to get going on this project. All the waiting around is killing me!